(Difference between revisions)
Revision as of 09:49, 18 August 2006 Peter (Talk | contribs) ← Previous diff |
Revision as of 09:52, 18 August 2006 Peter (Talk | contribs) (→'''A simple rainfall map for the current dekad''') Next diff → |
||
Line 19: | Line 19: | ||
|width="225"|With the world map as default, some cluttered data are shown for Bangladesh ||[[Image:graph38.jpg|400px|]] | |width="225"|With the world map as default, some cluttered data are shown for Bangladesh ||[[Image:graph38.jpg|400px|]] | ||
|--- | |--- | ||
- | |width="225"|Using the zoom buttons an image for just Bangladesh is selected. ||[[Image:graph39.jpg|300px|]] | + | |width="225"|Using the zoom buttons an image for just Bangladesh is selected. With the ''Copy-to-clipboard'' button this image can be copied to the clipboard and pasted into a word processor. ||[[Image:graph39.jpg|300px|]] |
|} | |} | ||
Revision as of 09:52, 18 August 2006
Preparation of ten-daily rainfall and ET0 maps for crop forecasting
Crop forecasting based on water balance calculations is usually done in a ten-day timestep. A ten day period is called a “dekad”. However, should daily weather data of good spatial and temporal extend be available, the water balance can be run in AgrometShell on a daily basis.
In order to do crop forecasting the following weather data have to be gathered:
- Actual decadal rainfall data for the running season.
- Actual decadal ET0 data for the running season
- Normal rainfall data
- Normal ET0 data
These data form indicators in itself, even without using them directly in a water balance calculation. Some examples are given below:
A simple rainfall map for the current dekad