CM Box User GuideMain Page | About | Special pages | Log in

Printable version | Disclaimer | Privacy policy | Current revision

Revision as of 10:04, 18 August 2006; view current revision
←Older revision | Newer revision→

Preparation of ten-daily rainfall and ET0 maps for crop forecasting

Crop forecasting based on water balance calculations is usually done in a ten-day timestep. A ten day period is called a “dekad”. However, should daily weather data of good spatial and temporal extend be available, the water balance can be run in AgrometShell on a daily basis.

In order to do crop forecasting the following weather data have to be gathered:

  • Actual decadal rainfall data for the running season.
  • Actual decadal ET0 data for the running season
  • Normal rainfall data
  • Normal ET0 data

These data form indicators in itself, even without using them directly in a water balance calculation. Some examples are given below:

A simple rainfall map for the current dekad

Start the “Database-Map” function. This example will display rainfall data for a specific dekad in 2002 for Bangladesh.
With the world map as default, some cluttered data are shown for Bangladesh
Using the zoom buttons an image for just Bangladesh is selected. With the Copy-to-clipboard button this image can be copied to the clipboard and pasted into a word processor.


Accumulated rainfall from the beginning of the season

In this example the accumulated rainfall for the season 1991-1992 is calculated. The example is for Zimbabwe where the season starts around November. The current dekad is assumed to be the second dekad of March 1992. Start the “Database-Export” function.
With the world map as default, some cluttered data are shown for Bangladesh
Using the zoom buttons an image for just Bangladesh is selected. With the Copy-to-clipboard button this image can be copied to the clipboard and pasted into a word processor.





0 Page generated in 0.206875 seconds.